SCCM R2 SP1 Deployment Task Sequences Bug

sccm logo
SCCM Logo

Estimated reading time: 1 minutes

Have you deployed a Task Sequence in SCCM R2 SP1 and then cannot see it when you PXE boot your machine? Well, this is a bug and it is very easily fixed.

All you need to do is go through your normal process of creating and deploying a Task Sequence, but after you have created the deployment, you need to go back into it and amend the “available from” date and time. This is due to a bug in the system in relation to time zones (apparently!).

So, go into your deployment, click the “Scheduling” tab and change the date to a few days ago and click ok:

SCCM R2 SP1 Deployment Task Sequences Bug 1

You should now see that your deployment is available to you now!

COMMENTS

If you have any questions or comments on this guide, please feel free to use our comments system below to leave us a message.

Share this content:

Click to rate this post!
[Total: 0 Average: 0]
Avatar for Andrew Armstrong

About Andrew Armstrong

Founder of TechyGeeksHome and Head Editor for over 15 years! IT expert in multiple areas for over 26 years. Sharing experience and knowledge whenever possible! Making IT Happen.

View all posts by Andrew Armstrong

One Comment on “SCCM R2 SP1 Deployment Task Sequences Bug”

Leave a Reply

Your email address will not be published. Required fields are marked *